Mangoh Green Configuration; Default Configuration - mangOH green User Manual

mangOH green User Guide
Table 3-6: mangOH green Default Configuration
Component /
Switch
•
Antenna connectors
(Main, Diversity,
•
GPS)
•
Audio connector
(CN500)
•
•
RS-232 connector
(CN700)
•
LEDs All LEDs are enabled and will exhibit their
default behaviors
System reset signal Held LOW until primary module is fully booted
(RESET_IN_N)
•
SIM1/SIM2 Detect
•
Rev 2 Jan.16
Figure 3-33: Reset Switches

mangOH green Configuration

Default Configuration

The mangOH green's default configuration is described in
Default Configuration / Behavior
U.FL connectors
3.3 V bias voltage for active antennas
Connected to onboard mangOH codec
CTIA/AHJ-compatible headset
Enabled
Connected to primary module's UART2
SIM1 Detect uses physical sensor to detect
SIM card insertion/removal
SIM2—Switch SW401 (position 4) can be
used to detect SIM2:
•
OFF—SIM2 detected
•
ON—SIM2 not detected
1—Board reset (SW400)
2—Arduino reset (SW1500)
SMA connectors can be added, if required, by a
user who is proficient at soldering. For details,
refer to the mangOH green schematic available
at mangoh.io.
Reconfiguration to use an OMTP-compatible
headset requires soldering.
Peripherals on the mangOH green are not
activated until the module is fully booted.
30
Table 3-6.
Notes
4117164