Messages - Sony MZ-RH910 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

Messages

If the following messages appear in the display window on the recorder, check the chart
below.
Message Meaning/Remedy
AVLS NO • AVLS is set to "On" and so the volume cannot rise higher.
VOLUME
OPERATION
BLANKDISC • A disc with no recording on it is inserted.
BUSY WAIT A • The recorder is accessing disc information.
MOMENT • You tried to operate the recorder while it was accessing the recorded data.
CANNOT EDIT • You selected, "Group Set", "GroupRelease", "Move", or "Erase" while
• You tried to erase the track mark at the beginning of the first track or group.
• You tried to erase a track mark to combine tracks the recorder cannot
• You tried to overwrite a track marks.
• You tried to change a title that includes characters the recorder cannot edit.
CANNOT • You tried to press X or T MARK during synchro-recording.
OPERATE
CANNOT PLAY • You tried to play a track that is subject to play restrictions.
• You tried to play an MP3 track with a format not supported by this recorder.
CANNOT • You tried to record on a disc that has already been recorded in MD mode.
RECORD
CANNOT • There is no audio data that can be played on the recorder.
RECORD OR • The audio data or disc management file has been damaged.
PLAY
CANNOT SET • You tried to set "Time Mark" during synchro-recording.
• You selected "REC Level" while the recorder is not in recording-pause.
• You tried to make the following settings while recording.
Charging • The rechargeable battery is being charged.
, Set AVLS to "Off" (page 56).
, Wait until the message goes out (in rare cases, it may take a few
minutes).
recording.
combine (a track recorded in stereo and in mono, for example).
, Editing titles cannot be done if the title includes characters that cannot
be input on the recorder.
, This recorder only supports MP3 tracks (MPEG-1 Audio Layer-3/
sampling frequency 44.1 kHz) that have been transferred using the
SonicStage software.
, On this recorder, you cannot do additional recording on a disc that is
already recorded in MD mode. If you want to do additional recording
on such a disc, connect the recorder to a computer and use the supplied
software.
, Erase the whole disc (page 53) or perform the Format function
(page 55).
, Set "REC Level" while the recorder is in recording-pause.
— Recording mode
— Disc Memory
— Play mode
— Selection of "Group REC" in menu
77