Cisco Firepower 1010 Mount The Chassis page 4

Hide thumbs Also See for Firepower 1010:

Wall-Mount the Chassis

Figure 3: Attach the Wall-Mount Bracket to the Chassis

Step 4

Use the two #6 x 1¼ inch screws to drill into a stud, or use the anchors (#8 wall screw) from the dry-wall kit to hang it

into dry wall.

If you are mounting the chassis onto something other than drywall, such as wood or sheet metal, anchors may not be

required.

Step 5

Drill a hole into the wall at each mark that you made in Step 2.

These holes should be slightly smaller in diameter than anchors if you are using them. The recommended drill hole size

is 3/16 inches.

Step 6

Insert the anchors into the holes if needed, and be sure they are properly seated.

Step 7

Fasten each screw into its anchor until it protrudes about 1/4 inch.

Step 8

Pick up the chassis, align the screws in the anchors with the holes in the bottom of the wall-mount bracket, move the

chassis toward the wall until the screw heads are in the wall-mount bracket, and then slide it down until it rests on the

screws.

Mount the Chassis