Cisco Firepower 1010 Mount The Chassis page 3

Hide thumbs Also See for Firepower 1010:

Mount the Chassis

• Three Phillips M3 x 6 mm screws (part number 48-0460-01)

• Two Phillips #6 x 1¼ inch screws (part number 48-2289-01)

• One anchor #8 wall screw (part number 51-4718-01)

Follow these steps to mount your chassis on a wall.

Step 1

Choose an orientation (left-, right-, or rear panel-side up) and a location on the wall for the chassis.

Step 2

Use a pencil, ruler, and level to mark locations for the two mounting screws (#6 x 1¼ inch). You can use the wall-mount

bracket itself to mark either the top holes or the side holes.

Figure 2: Wall-Mount Bracket

Vertical mounting

Step 3

Attach the wall-mount bracket to the chassis using the three Phillips M3 x 6 mm screws.

Horizontal mounting

Mount the Chassis

Wall-Mount the Chassis