Config Menu - Quasar Science R2 Quick Start Manual

> DMX Channel
> Number of Pixels
> Profile
> Wired Settings
> Wireless Settings
> Lead / Follow
> Output Mode
> Power On Mode
> Status Lights
> Languages
> Lamp Hours
> Update Firmware
> Firmware
> Reset to Default
11
Set the DMX Channel.
Set the number of pixel groups in the light to control in groups. (See Page 12)
Set the DMX profile for the light. (See Page 18-23)
Select the Wired data options to control the light. (DMX, Art-Net, sACN) (See Page 13)
Select the Wireless data options. (CRMX, Bluetooth, WiFi) (See Page 14)
Set Lead/Follow mode for the light. (See Page 15)
Set the light to Normal Output, High Output, or Low Output Mode. (See Page 16)
With Button, turns on with Power Button. With Input, turns on when power is connected. (See Page 16)
Turns the status lights on/off for use on camera.
English (Check the website for additional languages.)
Displays the total hours the light has been powered on. Press Enter to See LED Hours.
Set the light into Update mode.
Displays the firmware version on the light.
Sets the light back to all its default values.

Config Menu