Set New Recipe - Bunn ICB Operating & Service Manual

PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE (to set a new COFFEE recipe using
a Smart Funnel or RECIPE CARD)
Using a Smart Funnel and a G9-2T DBC or MHG
Grinder:
This function allows the operator to set BREW VOL-
UMES, BYPASS PERCENTAGE, PULSE BREW TIMES
AND DRIP OUT TIMES for each coffee name preset in
the grinder's memory.
SET TEMP XXX°
NO YES
CYCLES THROUGH
TWO SCREENS
(COFFEE NAME)
NO
BREW BREW
A
BEGIN SETUP OF
(COFFEE NAME)
SET UP BREW VOLUMES, BYPASS PERCENTAGE,
PULSE BREW TIMES, AND DRIP OUT TIME
2 BATCHES DONE?
NO
BREW
(COFFEE NAME)
SETUP COMPLETE

SET NEW RECIPE?

NO
BREW BREW
A B
INSERT FUNNEL
WITH NEW NAME
2 SEC.
QUIT SETUP?
YES
BREW BREW
A B
FUNNEL DETECTED
FUNNEL
CONTAINS NAME
YES
BREW
B C
YES
BREW BREW
A B C
Certain coffee names are stored in the grinder's memory.
When a particular name of coffee is ground into the
Smart Funnel, that name and the batch size selected
are transferred from the grinder to the programming
CHIP located in the funnel handle. The funnel is then
inserted into the brewer's funnel rails. The SENSING
COIL on the brewer reads the information contained in
the handle. The name of the coffee flavor will then ap-
pear on the display. This allows the operator to set the
BREW VOLUME, %BYPASS, PULSE BREW TIMES and
DRIP OUT TIME for that particular coffee name. It also
YES
allows the operator to set other brewing parameters,
such as BREW TEMPERATURE, BREW LOCKOUT, etc.
BREW
Each coffee name can be set individually to provide
C
optimum brewing quality.
BREW
C
FUNNEL CONTAINS
NO NAME
MUST GRIND INTO
FUNNEL FIRST
SEE SEPARATE DIAGRAMS
FOR SETUP INSTRUCTIONS
P2854
Page 22
37077 101205