Mounting The Seat; Mount And Tighten Screw - KTM 150 EXC TPI 2021 Setup Instructions

3 WORK
3.4
3.5
18

Mounting the seat

H02218-11
S03480-10
Removing the fuel tank
Danger
Fire hazard Fuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
–
Do not fuel the vehicle in the vicinity of open flames or lit cigarettes.
–
Switch off the engine for refueling.
–
Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
–
If any fuel is spilled, wipe it off immediately.
–
Observe the specifications for refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid skin, eye and clothing contact with fuel.
–
Immediately consult a doctor if you swallow fuel.
–
Do not inhale fuel vapors.
–
In case of skin contact, rinse the affected area with plenty of water.
–
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
–
Change your clothing in case of fuel spills on them.
–
Keep fuels correctly in a suitable canister, and out of the reach of children.
–
Mount the front of the seat on the two collar bushings of the
fuel tank, lower the seat at the rear, and push the seat forward.
–
Make sure the seat is latched in place correctly.
–

Mount and tighten screw

Guideline
Remaining screws,
chassis
Preparatory work
–
Remove the seat. ( p. 17)
1
on the left side.
M6 10 Nm (7.4 lbf ft)