Table of Contents
Advertisement
Alignment letters
Alignment
positions
Transducer
Transducer
bracket
Insert and align ratchets.
Transducer
Transducer bracket
Ratchet
Ratchet
Add ratchets to bracket and transducer.
2. Aligning the transducer on the transom.
A. One-piece bracket: Slide the transducer between the two ratch-
ets. Temporarily slide the bolt though the transducer assembly and
hold it against the transom. Looking at the transducer from the side,
check to see if it will adjust so that its face is parallel to the ground.
If it does, then the "A" position is correct for your hull.
If the transducer's face isn't parallel with the ground, remove the
transducer and ratchets from the bracket. Place the ratchets into the
14
Hide quick links:
Advertisement
Table of Contents
