Table of Contents
Advertisement
8. The CHANGER indicator light up when download completes
successfully. To restart the updated proglam, press the U but-
ton to turn OFF the power, and press it again to turn ON the
power again."
9. Enter "UPDATEF" and press the ENTER key. The following is
displayed on the screen.
10. Check the Revision here. Check that the Revision has been re-
written to that downloaded, enter "E", and press the ENTER
key to end the program."
Recovering when writing failed:
• If this unit does not operate normally after writing, perform writ-
ing again using the following procedure.
1. Remove the shield with the power OFF, set the "RECOVERY"
DIP switch to OFF, press the U button and turn ON the power.
2. Execute the "UPDATEF" and perform the writing process again
using the method described earlier.
3. After writing, turn OFF the power of the unit once.
4. Set the "RECOVERY" DIP switch to ON, and press the U but-
ton to turn ON the power.
5. Execute the "UPDATEF" using item 10 of the procedure de-
scribed earlier.
Check that "Revision" has been updated.
SCSI TERM
MODE
ID SELECT
4 2 1 4 2 1
DRIVE
CHANGER
RECOVERY DIP switch (Figure shows the ON state)
20
Check that the Revision is the downloaded revision.
Remove the
shield.
Advertisement
Table of Contents
