Safety Instructions; About This Chapter; Intended Use; Improper Use - Bosch Rexroth Hagglunds CBm Installation & Maintenance Manual

2 Safety instructions

2.1 About this chapter

This product has been manufactured in strict compliance with the generally
accepted rules of technology. However, this does not exclude the risk of damage
to persons or property if this chapter and the safety instructions included in the
present documentation are not observed.
▶ Read the entire documentation carefully before starting to use the product.
▶ Keep this documentation in a location where it is accessible to all users at any
time.
▶ When passing over the product to third parties, make sure to include the
necessary documentation.

2.2 Intended use

The Hägglunds CBm is a radial piston hydraulic motor.
In an application the CBm motor is classified as component. The CBm motor
may only be commissioned after it has been installed in the machine/system for
which it is intended and the safety of the entire system has been established in
accordance with the machine
The product is intended for professional and not for private use.
Intended use includes having read and understood the entire documentation, in
particular the "Safety instructions" chapter.
The product is intended for the following use:
• Radial piston motor in open or closed circuit: The radial piston motor is approved
to be used in motor mode or pump mode.
Observe the technical data, application and operating conditions and performance
limits as specified in the product-specific data sheet and in the order confirmation.

2.3 Improper use

Any use other than that described as intended use shall be considered as improper
and is therefore impermissible.
Bosch Rexroth shall accept no liability whatsoever for damage resulting from
improper use. The user shall bear all risks arising from improper use.
Similarly, the following foreseeable faulty usages are also considered to be
improper:
• Using outside the operating parameters approved in the product-specific data
sheet or in the order confirmation (unless customer-specific approval has been
granted)
• Use of fluids outside of the standards as specified in 15.1.1: Hydraulic fluids and
in Data sheet RE 15414 Hydraulic fluid quick
• Modification of factory settings by non-authorized persons
• Use of add-on parts (e.g. mountable filter, control unit, valves) that are not
specified by Bosch Rexroth has to be approved by contact at Bosch Rexroth.
directive.
reference.
RE 15300-WA, Version 06.2021, Bosch Rexroth AB
Safety instructions 7/72