Preparing The Components For Storage Or Further Use - Bosch Rexroth Hagglunds CBm Installation & Maintenance Manual

68/72 Removal and replacement
Included in coupling
adapter
1 Lifting eye
2 Dismounting tool
3 Screws
Assembly tool for coupling
adapter
4 Nut and washer
5 Carriage beam
Bosch Rexroth AB, RE 15300-WA, Version 06.2021
Removing the coupling adapter
1. Secure the coupling adapter to a lifting device, see chapter 6.1: Product
transport.
2. Install the assembly tool by pass the tie rod through the centre of the coupling
adapter and screw it into the driven shaft by using a wrench at the key grip at
the end of the assembly tool.
3. Mount the nut and then the washer tight to the coupling adapter. Mount the
dismantling tool with the screws to the coupling adapter.
4. Mount one lifting eye above the dismounting tool at the end of the coupling
adapter.
5. Mount two lifting eyes on the opposite side of adapter shaft.
6. Untighten the screws on the shrink disc gradually, appr. a quarter turn each.
Keep doing this until all screws are untighten.
7. Remove the coupling-adapter from the customer shaft by turning the nut on the
mounting tool counterclockwise.
Coupling adapter
4
Fig. 62: Assembly tool for removing the coupling adapter

11.4 Preparing the components for storage or further use

Proceed as described in chapter 6.2: Product storage.
1 2 3 5
DD00058172