Volvo Penta KAD/KAMD44P Operator's Manual page 84

Fault-tracing
82
Calibration. Electronic single lever
control
NOTE! When calibrating the control for two engines,
both the control levers must be calibrated at the same
time so that the lever positions are the same for both
engines.
1. Put the EDC system in calibration mode according
to the instructions in "Preparations".
2. Move the control lever to the position where For-
ward movement throttle opening is to start (1).
Release the lever and confirm the position by
pressing the neutral button for at least three sec-
onds.
3. Move the lever to the position for full speed ahead
(2).
Release the lever and confirm the position by
pressing the neutral button for at least three sec-
onds.
4. Move the lever to the position where reverse throt-
tle opening is to begin (3).
Release the lever and confirm the position by
pressing the neutral button for at least three sec-
onds.
5. Move the lever to the position for full speed re-
verse (4).
Release the lever and confirm the position by
pressing the neutral button for at least three sec-
onds.
6. Return the lever to the neutral position. Release
the lever.
7. Confirm and exit the calibration by pressing the
neutral button twice for at least three seconds.
The indicator in the neutral and diagnostic buttons
stops flashing to confirm that the calibration is
complete.