Volvo Penta KAD/KAMD44P Operator's Manual page 68

Maintenance: Drive
1
4
66
2
3
2
DP drive
The sacrificial anodes can be found at the lower edge
of the shield (1) and on the gear housing in front of the
propellers (2).
Undo the two screws holding the anode (1). Remove
the anode and the support plate under the anode.
Clean the mating surface. Reinstall support plate and
the new anode.
Disassemble the propellers in accordance with the in-
structions in the "Propellers" section. Undo the two
screws holding the anode (2). Remove the anode.
Scrape mating surface on the drive clean. Install new
anode.
DPX drive
The protective anodes are located on both sides of the
upper bevel drive housing (1), the steering cylinders
1
(2), on top of the cavitation plate (3) and underneath
the shield (4).
All anodes are fixed with screws. Undo the screws
which hold the anode. Clean the mating surface and
install the new anode.
There is a support plate inside the anode (4) which
holds the trim sensor in place. Carefully check that the
support plate locks the trim sensor before installing the
anode and tightening the screws.
WARNING! Risk of water entry. Check that the
support plate locks the trim sensor before install-
ing the anode.