Software Licences; Commissioning; Your System Is Preset - Viessmann VITODENS 100-W B1HE Operating Instructions Manual

Vitodens 100-W B1HE/B1KE Operating

Software Licences

Commissioning

Your System is Preset

Your heating system is preset at the factory and is
therefore ready for operation following commissioning
by your contractor:
Note: The following paragraph "DHW heating" is not valid
for operation with a DHW tank with temperature
switch (such as an Aquastat).
This product contains third party software, including
open source software. You are authorized to use this
third party software in compliance with the relevant
licensing terms.
Licences for the integrated wireless module:
See page 23.
Licences for the programming unit: See page 23.
The commissioning and matching of the boiler to local
conditions and building characteristics, as well as
instructing the user in the operation of the system, must
be carried out by your contractor.
DHW tank heating
Between 05:30 and 22:00, the DHW is heated to
122°F (50°C) ("Standard" temperature level).
Between 22:00 and 05:30, the DHW tank is not
reheated.
DHW tank heating
Between 05:30 and 22:00, the DHW is heated to
122°F (50°C) "Set DHW temperature". Any installed
DHW recirculation pump is switched on.
Between 22:00 and 05:30, the DHW tank is not
reheated. Any installed DHW recirculation pump is
switched off.
Note: Any DHW heating started before 22:00 remains
on until the target DHW temperature has been
reached.
DHW comfort function
Only for Vitodens 100-W B1KE boilers. Your heating
contractor can activate the DHW comfort function.
This makes DHW available faster.
Frost protection
Your boiler and DHW tank (if installed) are
protected against frost.
Wintertime/summertime changeover
This changeover is automatic.
Date and time
The date and time were set by your heating contractor.
You can change these settings at any time to suit your
individual requirements.
Power failure
All settings are saved if there is a power failure.
General Information
9