Checking Service Messages - Viessmann VITODENS 100-W B1HE Operating Instructions Manual

Calling Up Information
Calling Up Licences for the Integrated Wireless Module
Third party software
Overview
This product contains third party software, including
open source software. You are entitled to use this third
party software in compliance with the respective licence
conditions as provided under the link below.
A list of the third party software components used and
of licence texts can be accessed by connecting your
boiler, as explained in the instruction manual.

Checking Service Messages

24
Vitodens 100-W B1HE/B1KE Operating
Acknowledgements
Linux® is the registered trademark of Linus Torvalds in
the U.S. and other countries. This product includes
software developed by the OpenSSL Project for use in
the OpenSSL Toolkit (http://www.openssl.org/).
This product includes cryptographic software written by
Eric Young (eay@cryptsoft.com) and software written by
Tim Hudson (tjh@cryptsoft.com).
Disclaimer
The open source software contained in this product is
distributed WITHOUT ANY WARRANTY; without even
the implied warranty of MERCHANTABILITY or FITNESS
FOR A PARTICULAR PURPOSE. The single licences may
contain more details on a limitation of warranty or liability.
How to obtain the source code
The software included in this product may contain
copyrighted software that is licensed under a licence
requiring us to provide the source code of that software,
such as the GPL or LGPL. To obtain the complete
corresponding source code for such copyrighted software,
please contact us via the contact information provided
in section 5 below, indicating the build number you will
find under the "Open Source Licences" link mentioned in
section 1 above. This offer is not limited in time and is
valid for anyone in receipt of this information.
Your contractor can set service intervals. "Active
messages" is displayed if these service intervals are
exceeded.
Tap the following buttons:
1. OK to confirm
2.
3. for "Active messages"
4. OK to confirm
5. for "Maintenance"
6. OK to confirm
7. for the required message
8. OK to confirm
Further information regarding the message is displayed.
9. Make a note of the service message number. For
example: P.1 "Interval until the next service".
This enables the contractor to be better prepared
and may save you unnecessary travelling costs.
10. Please notify your contractor.
Note: If the service cannot be carried out until a later
date, the service message will be displayed again
the following Monday.
11. for approx. 4 sec, to exit the menu.
(continued)