Scanning Service Messages - Viessmann Vitocrossal 100 Operating Instructions Manual

Calling up information
Scanning information and resetting values
Shown on display
0 0 1 4 2 5
6
0 0 0 5 0 6
7
0 0 0 5 0 6
8
0 0 2 8 5 0
9

Scanning service messages

Your heating contractor can set a service interval. For
example, service after 2500 hours run by the burner or
service after 12 months.
If your heating system is due for a service, " " flashes
on the display and the expired service interval is
shown.
Example:
Service display with the service interval of 2500 hours
run by the burner:
2 5 0 0
Fig. 5
Service display with the service interval of 12 months:
1
Fig. 6
16
Meaning
Pump starts, solar circuit pump
h Hours run, output 22
Pump starts, output 22
Solar yield in kWh
ë
h
ë
2
(cont.)
Notes
Displayed only if a Viessmann solar control
module is installed.
Pump starts can be reset to "0" with "
Displayed only if the Viessmann solar con-
trol module is available and a second circu-
lation pump has been connected.
The hours run can be reset to "0" with "
Displayed only if the Viessmann solar con-
trol module is available and a second circu-
lation pump has been connected.
Pump starts can be reset to "0" with "
Displayed only if a Viessmann solar control
module is installed.
The yielded solar energy can be reset to "0"
with " ".
D
Notify your heating contractor. Acknowledge the serv-
ice message with OK.
Note
If the service can only be carried out later, the service
message will reappear after 7 days.
Calling up an acknowledged service message
Hold down OK for approximately 4 seconds.
".
D
".
D
".
D