Load A Set-Up - Kodak II 3478 Installation And Setup Manual

Installation and Set-up Manual

3.7.2 Load a Set-up

The setup is saved in such a way it may be saved from one camera using one version of
the KNIC firmware and later downloaded to another camera with a later version of the
firmware.
To load a set-up from a PC the following must be performed:
• Connect a PC to the Kodak Network ID Camera.
• Enter "Remote control" and select which communication port and speed to use.
• Press F1 "Connect", a text "Waiting" appear on the display. The camera is now ready
for a transmission session.
• Type "putsetup [options] filename" at the DOS-prompt and press ENTER.
Options are -p where port is 1 or 2 for COM1 or COM2
Filename is the name of an existing file.
If the command line is given with no options port COM1 will be used and the speed
will be set to 38400.
Before the setup is re-loaded the previous setup will be erased. If download is
interrupted for some reason a new download must be performed. If there is
problems to download a set-up, even at lower speed, the setup should manually be
erased. This since the partially loaded setup may be inconsistent causing the
camera to behave incorrectly. To manually erase a set-up (i.e resetting to factory
default), please refer to chapter 3.2.
• When all is done, press F4 to exit remote mode. The camera will ask you to press any
key to restart with the new set-up.
4/99
-s where speed is 4800,9600,19200 or 38400.
20
II 3478
Kodak AG Stuttgart