Sensor Adjustment; Test Functions; Serial Analyzer; Remote Control - Kodak II 3478 Installation And Setup Manual

II 3478

3.3.4 Sensor adjustment

This selection will show a picture showing the status of the three cassette sensors. For
detailed information, please refer to the Service manual.

3.3.5 Test functions

Here parameters regarding the opening of the cassette window can be set. For detailed
information, please refer to the Service Manual.
NOTE: This should only be done by trained service personnel.

3.3.6 Serial analyzer

Here all data, received on HOST or NET serial communication port, is listed. For detailed
information, please refer to the Network Installation Manual.

3.3.7 Remote control

Here the down-/upload of a set-up is performed.

3.3.8 System logger

Here is listed errors and abnormal situations. For detailed information, please refer to the
Service Manual.
3.4

Pictures and settings

Choosing this selection will present five new alternatives.

Picture

Settings
Picture
Settings
Menues
3.4.1 Picture
Here the layout of the picture printed on the film is defined. Two different pictures can be
defined, "Standard, C1" and "Min-R2, C1N". The C1N window is narrower than the C1
window (6 lines instead of 8 if the small font is used), but this is not reflected by the
configuration alternatives, instead it is the responsibility of the person creating the setup
not to put anything information outside the window.
Kodak AG Stuttgart
Standard, C1
Standard, C1
Min-R2, C1N
Min-R2, C1N
5
Installation and Set-up Manual
4/99