Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Kodak EP101WG
Summary of Contents for Kodak EP101WG
-
Page 1: Quick Start Guide
KODAK Security Camera EP101WG Quick Start Guide For detailled installation and setup, please refer to the Model EP101WG complete User’s Guide available on our website : www.be-connected.com... - Page 2 TWO YEARS LIMITED Warranty LIZ INVEST (the “Company”) warrants the KODAK Security Camera & KODAK Smart Alarm System (the “Product”), and only the Product, against defects in materials and workmanship under normal use for a period of two-years from the date of purchase by the original purchaser (“Warranty Period”).
-
Page 3: Operating Precautions
OPERATING PRECAUTIONS The camera must not be installed in a location where the lens filter is exposed to scratching and dirt. - Do not expose the lens to direct sunlight or any reflective light source. - Do not install near acid chemicals, ammoniac or a source of toxic gas emissions. - The camera must be installed and used in compliance with local legislation MAINTENANCE AND CLEANING - Always unplug the product from the mains before carrying out any maintenance. - Page 4 IN THE BOX Antenna Ethernet Cable Mount Bracket MicroSD Reset Power cable Lens Light Sensor Microphone KODAK Security Camera EP101WG Quick Start Guide AC Power Adapter LAN Cable Screw/Anchor Kit...
-
Page 5: Getting Started
GETTING STARTED Connection tests are recommended before fitting the camera in its final location. Drill the mounting holes by Hang the camera on the using the alignment paper. 4 screws, then fasten 4 screws by using hex key. Screw antenna into rear of camera. Plug it into the outlet you want to use. - Page 6 HD-XXXXXX Network. 4 When asked for a password, enter « 12345678 » Tap Join to connect. 5 Now Launch the KODAK Security Application. 6 Tape « + » to start the installation and select « Wifi cameras ». 7 Once connected, the screen will indicate that the camera has been successfully configured.
- Page 7 APP INSTALLATION / ANDROID 1 From your smart device, download and install the free KODAK Security Application 2 Tape « + » on screen for direct wireless connection of the camera to the application. 3 Plug the camera into an electrical outlet (allow the camera up to 90 seconds to boot up).
-
Page 8: App Installation
Tap to RECORD. One-minute (approx.) Recordings save to microSD card on the side 58 % KODAK Security of camera; see diagram page for location Connected HD Camera (Live View) (microSD card not included). Tap to turn volume ON/OFF in the Live View mode. -
Page 9: Add Sensors
ADD SENSORS Add Sensors Your camera can work with up to 6 KODAK Security Accessories : Door Sensor, Motion sensor or remote control. Please follow the installation process as below : 1 Tap in camera Panel 2 In the advanced section, enter admin password default 123456. - Page 10 For detailled installation and setup, please refer to the Model EP101WG complete User’s Guide available on our website : www.be-connected.com The Kodak trademark, logo and trade dress are used under license from Kodak.