Table of Contents
Advertisement
II 3478
3.4.5 Settings Standard, C1/Min-R2, C1N
If Settings Standard, C1 is selected, the following will be displayed:
Settings
Status:
Exposure:
Intensity:
Name: Standard, C1
The cursor is located at "Status" and can be moved between the different settings by
pressing up- and down-arrow keys. If the softkeys Previous and Next are visible it is two
or more predefined values that can be selected by pressing the corresponding function
keys F2 and F3.
The following settings can be performed:
Status
Exposure
Intensity Intensity of the exposure display. Selectable values are 0.4, 1, 1.8, 4.5 and
Name
Text
Location Toggle between Bottom/Top. Determine whether the picture should be
Kodak AG Stuttgart
Used
Text:
550 ms
Location: Bottom
1
Vert adjust:
Previous
Next
Toggle between Used/Not used (i.e enable/disable the picture). If one
picture is switched to "Not used" the other one will automaticly be switched
to "Used". A "Not used" picture can not be accessed by the operator.
Factory default is Used.
Basic exposure time in millisecundes. A value between 10 and 65535 can
be set. A value less than 300 will cause vertical pattern to appear because
of interference with the refresh rate of the exposure time. Factory default is
550.
The actual exposure time is the basic exposure time set in this window
multiplied by a factor determined by the exposure correction set in the
exposure window that is opened from the patient data window. The
correction factor is:
1
2
3
0,5
0,6
0,71
10. Factory default is 1.
The name of this picture. Can be edited to any name with a maximun length
of 15 characters. Factory default is "Standard, C1" and "Min-R2, C1N".
Toggle between Normal/Inverted. Determine whether the picture should
show white text on black background or black text on white background.
Factory default is Normal.
printed on bottom or top of the film. Factory default is Bottom.
NOTE! If a window is set-up for a MIN-R2 cassette bottom marking and then
is changed to top marking the lower 16 pixel-lines of the image will be
placed outside the cassette window. This means that the whole image must
be moved 16 pixel-lines up, field by field, to fit the MIN-R2 cassette window.
Normal
0
Save
4
5
6
7
0,84
1
1,19
1,44
9
Installation and Set-up Manual
8
9
1,68
2
4/99
Advertisement
Table of Contents
