Advertisement
Technical Data MBAL-PRO75
• Weight: 500 g (1.10 lbs)
• Size: 48 × 75 × 101 mm (1.90 x 2.95 x 3.98 in.)
• Diameter: 75 mm (2.95 in.)
• Connection tripod side: Insert connection for TRIOPOD-PRO75 plus 1/4" and 3/8"
• Connection camera side: Turnable stud screw 1/4" and 3/8"
• Adjusting angle: +/- 15°
• Max. Load: 20 kg (44.1 lbs)
Handling
In order to level a mounted device with the horizon, loosen the fixing lever (2) and level the
device with the help of a spirit level. After that tighten the fixing lever again.
All Novoflex panorama plates have corresponding spirit levels for judging accurate level-
ling.
Installing the Levelling Ball on the TrioPod PRO75 Tripod
The levelling ball MagicBalance PRO 75 can be easily combined with the Novoflex
TrioPod PRO75 tripod by inserting it into its 70 mm tripod basis mouth.
4
4
4
Removing the Upper Tripod
Platform
For this, loosen the three
headless screws (4) out of
the tripod basis at about 2/3 of
their length. Use the hex key
which is part of the Multi-Tool
(included in the scope of de-
livery of the tripod).
After that, pull out the tripod
platform.
Installing the Levelling Ball MBAL-PRO75
First unscrew the fixing lever (2) completely out
of the housing.
Remove the distance shell (1, see illustration at
front page). This part is only needed when the
levelling ball is used independently from the
Novoflex TrioPod PRO75.
Now insert the levelling ball from above into
the 70 mm tripod basis mouth. For this bring the
white marking dot on the MBAL's housing in
line with the white marking line on the basis (5).
The hole for the fixing lever is located straight
below.
After that screw the fixing lever from outside
through the basis hole into the levelling ball
(without distance shell), until it can no longer
be turned.
At the end, tighten the three headless screws
(4) at the tripod basis again.
6
4
5
4
2
Thread Hole Exchange at the Bottom Side: 3/8" for 1/4"
Inside the 3/8" standard thread hole at the bottom side (3, see illustration at front page)
there is a 1/4" reducer bushing, which can be removed if needed. Unscrew this adapter
for a 3/8" thread. This hole can be used to connect the levelling ball with tripods from third-
party manufacturers.
2
Stud Screw Exchange:
3/8" for 1/4"
For changing the upper stud
4
screw thread, remove the screw
(6) using a screwdriver (Multi-
Tool, included in the scope of
delivery of the tripod), turn the
screw upside down and screw
it back in again. On one side the
screw has a 3/8", on the other
side a 1/4" thread.
Advertisement
