Hand/Arm Vibrations - Fein BLS 1.6 E Instruction Manual

Do not rivet or screw any name-plates or
signs onto the power tool. If the insulation is
damaged, protection against an electric shock
will be ineffective. Adhesive labels are recom-
mended.
Do not use accessories which are not specifi-
cally designed and recommended by the
power tool manufacturer. Safe operation is
not ensured merely because an accessory fits
your power tool.

Hand/arm vibrations.

While working with this power
WARNING
tool, hand/arm vibrations
occur. These can lead to health impairments.
The vibration emission value
WARNING
during actual use of the power
tool can differ from the declared value
depending on the ways in which the tool is
used.
It is necessary to identify safety
WARNING
measures to protect the oper-
ator that are based on an estimation of expo-
sure in the actual conditions of use.
The vibration emission level given in this
information sheet has been measured in
accordance with a standardized test given in
EN 62841 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of the vibrational impact.
The declared vibration emission level repre-
Emission values for sound and vibration (Two-figure – specifications as per ISO 4871)
Sound emission
Order number
A-weighted emission pressure power
level measured at the workplace
20 μPa), in decibels
Measuring uncertainty
Measured A-weighted sound power level
L
(re 1 pW), in decibels
wA
Measuring uncertainty
C-weighted peak sound pressure level
measured at the workplace
decibels
L
(re
pA
K
, in decibels
pA
K
, in decibels
wA
L
, in
pCpeak
Clean the ventilation openings on the power
tool at regular intervals using non-metal
tools. The blower of the motor draws dust
into the housing. An excessive accumulation
of metallic dust can cause an electrical hazard.
Before putting into operation, check the
power connection and the power plug for
damage.
Recommendation: The tool should always be
supplied with power via a ground fault circuit
interrupter (GFCI) with a rated current of
30 mA or less.
sents the main applications of the power tool.
However, if the power tool is used for other
applications with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
vibrational impact over the total working
period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when
it is running but not actually doing the job.
This may significantly reduce the vibrational
load over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: Maintain the power tool and the
accessories, keep the hands warm, organiza-
tion of work patterns.
BLS 1.6 E BLS 2.5 E
(**) (**)
7 230 .. 7 230 ..
81.6 81.8
3.0 3.0
92.6 92.8
3.0 3.0
95.5 95.2
BSS 1.6 E BSS 1.6 CE
(**) (**)
7 230 .. 7 230 ..
80.5 80.5
3.0 3.0
91.5 91.5
3.0 3.0
94.7 94.7
en
5
BSS 2.0 E
(**)
7 230 ..
79.2
3.0
90.2
3.0
92.7