Working Instructions; Switching On And Off - Fein BLS 1.6 E Instruction Manual

Working instructions.

Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.

Switching on and off.

Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
While cutting, hold the power tool as upright
as possible to the work-piece surface
(BLS 1.6 E and BLS 2.5 E).
Guide the power tool uniformly and with
light feed in the cutting direction. Excessive
feed considerably reduces the tool life of the
application tools.
Switching on and off (figure 4).
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
Do not cut steel sheets where welded. Do
not cut layered sheets exceeding the max.
work-piece thickness.
To increase the tool life of the blades, it is rec-
ommended to apply a lubricating agent along-
side the intended cutting line:
– For cuts in steel sheet: Use cutting paste or
cutting oil.
– For cuts in aluminum: Use petroleum.
Do not switch the power tool off until after
having removed it from the cutting path.
The symptom for worn blades is a clearly
increased feed force at lower working prog-
ress.
BSS 1.6 E (**), BSS 1.6 C E(**), BSS 2.0 E (**):
For inside cuts, a pilot hole is required; see
"Technical Data".
Fig. 4
On/off switch
en
13