Table of Contents
Advertisement
Setting Up (continued)
Setting Up (continued)
Adjusting The Projector's Elevator
WARNING • Do not touch about the lens and ventilation openings during use or
immediately after use to prevent a burn.
CAUTION • Do not incline the projector rightward or leftward. Also do not incline
it backward or forward exceeding 9 degrees. Exceeding these range could cause
malfunction, and could shorten the lifetime of the consumables.
• To prevent damaging the projector and injuring yourself, always hold the projector
whenever using the elevator buttons to adjust the elevator feet.
You can use the elevator feet to make adjustments if the surface on which you need to set
the projector is uneven or if you otherwise need to adjust the angle of projection. The
adjustment range of the elevator feet is 0 to 9 degrees.
Press and hold in the elevator buttons.
1
Raise or lower the projector to the desired height and
2
then release the elevator buttons.
When you release the elevator buttons, the elevator
feet will lock into position.
As necessary, you can also finely adjust the height of
3
the projector by twisting the elevator feet by hand.
Using The Lens Shift Buttons
The lens of this projector can be shifted
vertically. When you want to finely adjust the
picture position, use the LENS SHIFT buttons
of the projector.
LENS SHIFT buttons
Projector
LASER INDICATOR
STANDBY/ON VIDEO
RGB
+
+
+
LENS SHIFT
FOCUS
ZOOM
–
–
–
BLANK
ASPECT
LASER
Remote control
Elevator buttons
Elevator feet
7
Advertisement
Table of Contents
