FETtec FC G4 Manual page 7

Receiver connector:
GND
•
5V
•
TLM: Telemetry signal to receiver (see page 10 receiver connection diagram for further
•
information)
Signal: Receiver signal to FC (see page 10 receiver connection diagram for further
•
information)
6 pin connector (SER1):
RX1: function configurable in GUI
•
TX1: function configurable in GUI
•
3,3V
•
VCC: Battery voltage
•
5V
•
GND
•
Acronym explanation:
BEC 5V/16V: switchable voltage (in GUI) and real Pit capable
•
GND: Reference Signal Ground
•
Onboard OSD Jumper: bridge to deactivate onboard OSD and to activate RX4 and TX4
•
Real Pit VCC: real Pit capable VCC pin
•
Reset: Reset button to force the FC in bootloader mode, not needed for normal operation
•
SIG.: receiver signal (serial)
•
TLM: Telemetry signal output for receiver (Serial)
•
TLM / Onewire: ESC telemetry input or Onewire signal depending on configuration
•
VCC: Battery input voltage (6V-27V)
•
VCS: Video control signal (smart audio/tramp)
•
VID. in: Analog video signal to OSD
•
VID. out: Analog video signal from OSD
•
Page 7