Table of Contents
Advertisement
Taking Measurements
Pressure to Display (P-DISPLAY) Task
P-Display is a special application of Datalog. To use this mode, select Datalog
from the Store Mode menu as detailed on Page 36. Connect the device under test
to the instrument as shown below and, if required, turn on and set-up Cal Mode
(see page 11).
External Pressure Source
(Indicator Only)
Pressure
Regulator
•
Press TASK and select P-DISPLAY. If required, use OUTPUT key to change
pressure units.
•
Set-up a datalog file as detailed on Page 30.
Note: TRIGGER f ield, automatically set to KEYPRESS, cannot be changed.
•
Apply a series of test pressures to the device under test. Enter displayed
reading at each pressure and log each point (e.g.),
•
After logging final test point, terminate as follows (e.g.),
TASK : P-DISPLAY
SNAPSHOT MODE
DISPLAY
PRESSURE INT
15
TEST UNIT
(Dial Gauge)
max 30V
DPI 615 IS
bar
CHANGE
VALUE
F1
F2
K249 Issue No. 4
Advertisement
Table of Contents
