Temperature; Change Pin Number; Add External Sensor - GE Druck DPI 610 IS User Manual

Calibration

Temperature

• Precision Temperature Meter.
On completion of calibration routines, exit the calibration mode by pressing the
EXIT function key.

Change PIN Number

To change the PIN number, select CHANGE PIN from the calibration menu and
proceed as follows. Note that to set and verify a new PIN number, the new PIN
number must be entered twice.
If the second number entered differs from the first, no new PIN number is set.

Add External Sensor

To add an external sensor to the directory of external sensors, proceed as follows.
• Plug the external transducer into the connector located on top of
the instrument and proceed as shown below.
EXT SENSORS
SERIAL No. RANGE
bar
ADD NEW
SENSOR
Digitally-compensated transducers will be downloaded into the directory as soon
as the F1 key is operated. Data for other types can be edited by selecting EDIT
(F2). If the data cannot be edited a warning message (ACTION INVALID) is
displayed.
Cleaning Instructions
Clean the case of the instrument by using a damp cloth and mild detergent.
Note: DO NOT use any solvents to clean the instrument.
K249 Issue No. 4
EXT SENSORS
SERIAL No. RANGE
TYPE
bar
1154738 20.000
ADD NEW
SENSOR
42
EXT SENSORS
TYPE SERIAL No. RANGE
bar
g 1154738
EDIT
REMOVE
TYPE
20.000 g
CHANGE
DETAILS