Sony LF-B1 Operating Instructions (LF-PK1) Operating Instructions Manual page 31

Configuring the Remote
Control for Video 1 and Video 2
1
Click anywhere in the window to display the
index, then select [Settings] at the bottom
right of the window.
2
Select [TV/Video Settings], [Remote
Settings], and then [Video 1] or [Video 2].
1 Select the make of the connected device.
2 Select the type of the connected device.
3 If the configuration above is correct, each
time you click [Power], you can turn on
or off your device.
After clicking [Power], it takes five
seconds or more for the device to
respond.
If it does not work, make sure that the
make and type are correct, and then try
again.
Notes
• Even if the power turns on and off correctly
with [Power], other buttons may not be
enabled. If this happens, select [Video 1] or
[Video 2] from the Index. With the on-screen
remote, confirm that the buttons are enabled.
• Some devices may not have a [Power] button
(e.g. DVR). In this case, as well, use the on-
screen remote to display [Video 1] or [Video 2]
and confirm that the buttons are enabled.
When connecting two devices to
Video 1 or Video 2
Configure the remote control settings for
each remote.
When connecting an all-in-one video
device, such as a VCR+DVD player
The second remote is automatically set when
you select a device displayed as an all-in-one
device from the [Type] list (e.g., Sony
"VCR+DVD player"). Select the [Switch]
button on the on-screen remote to switch
between the remote control of the VCR and
that of the DVD player.
3
Click [OK] or [Apply].
Click [OK] to enable the settings and close
the [Settings] window.
Click [Apply] to enable the settings without
closing the [Settings] window.
1
2
z
Tip
After configuring the remote control for Video 1
and Video 2, the [Video 1] and [Video 2] options
in the [index] window change to their set remote
control names.
3
31