Locationfree Player System Requirements; Installing And Uninstalling Locationfree Player - Sony LF-B1 Operating Instructions (LF-PK1) Operating Instructions Manual

LocationFree Player
System
Requirements
Computer requirements (where
LocationFree Player is installed)
Operating system:
Windows 2000 Professional Service Pack 4
Windows XP Professional/Home Edition
Service Pack 2
Processor:
Pentium 4, 1 GHz or more
RAM:
256 MB or more
Available hard disk space:
300 MB or more
Monitor resolution:
800 x 600 pixels or more, HighColor (16 bit) or
more
Other:
• A wireless LAN card that complies with
IEEE802.11b, IEEE802.11g or
IEEE802.11a. The card must support WEP
encryption. (Required to connect directly to
the base station via a wireless LAN.)
• A 10BASE-T or 100BASE-TX LAN
connector. (Required to connect via a wired
LAN.)
Note
Some video cards (graphic cards) may distort video
picture while using the LocationFree Player. If you see
distorted images while using, please be sure to check
your PC manufacture's web site for the latest driver
software.
Installing and
Uninstalling
LocationFree Player
Use the procedures in this section to install and
uninstall LocationFree Player.
Installing LocationFree Player
Software
z
Tips
• LocationFree Player is compatible with Windows
XP (Service Pack 2) and Windows 2000
Professional (Service Pack 4). It cannot run on other
operating systems.
• LocationFree Player must be installed from a user
account with administrator privileges. Before
performing the installation, log on to Windows as a
user with administrator privileges.
• If Microsoft DirectX 9.0 is not installed on the
computer where you choose to install LocationFree
Player, it is installed at the same time you install
LocationFree Player.
Notes
• 3ivx is installed at the same time as LocationFree
Player. 3ivx is essential to the proper operation of
LocationFree Player and it should not be removed.
• If LFA-PC1 is installed, LFA-PC2 cannot be
installed. Uninstall LFA-PC1 before you install
LFA-PC2.
1
Insert the LocationFree Player software
CD-ROM into the CD-ROM drive of your
computer.
The installation wizard starts.
If the installation wizard does not start, find
the "setup.exe" file on the CD-ROM, and
then double-click it.
32