Checking The Dicom Network Connection; Example Of Connection; Connecting The Interface Cable - FujiFilm FM-DP L Service Manual

INSTALLATION 8. CHECKING THE NETWORK CONNECTION
8

CHECKING THE DICOM NETWORK CONNECTION

Example of Connection

Hospital network

Connecting the Interface Cable

CAUTION
Do not connect telephone lines to CN7 of the LAN90A board. Only the IEC950/UL1950
standard cables are appropriate for connecting to this connector.
<NOTE>
To prevent damage by static electricity, be sure to attach the protective cap to the
connector for unused external I/F.
(1) Check that the power of the equipment is OFF.
(2) Attach the ferrite core to 10BASE-T/100BASE-TX cable (UTP).
<NOTE>
• Attach the ferrite core at 20 to 30 mm from the cable connector.
• Tie the two cables together with the tie band.
<SUPPLEMENTARY NOTE>
UTP: Unshielded type
(3) Connect the 10BASE-T/100BASE-TX cable (UTP) to CN7 of the LAN90A
board.
(4) Attach the protective cap provided to metal connectors which are not
connected.
006-252-05
06.30.01 FM3040
DICOM PROTOCOL
10BASE-T/100BASE-TX
FM-DP L
Modalities of other
manufacturers
LAN90A
FP3B0713.EPS
FM-DP L Service Manual
B8-1
B8-1