Table of Contents
Advertisement
INSTALLATION APPENDIX 1 SETTING, CONNECTING, ADJUSTING THE IMAGE I/F BOARD
(2)
Remove the connector cover for CN3 (labeled OPTICAL DATA on the board
retaining panel) of the OPR06A board, and connect the optical fiber cable to
it. Secure the tension member for cable reinforcement as well.
(3)
After connecting the optical fiber cable, remove the protective spiral tube.
[Connect] Optical fiber cable
OPTICAL DATA
connector
Tension member
retainer
NOTE
• Carefully handle the optical fiber cable since it is very flexible and thus
may likely be broken or otherwise damaged when handled carelessly.
• Especially, handle a connector-attached cord carefully: use care not to
drop it, bump it against any object, or bend its cord portion sharply.
• Do not remove the connector cover unless the connector is to be
connected.
• Make sure that the optical fiber cable is protected by the tension member
when it is pulled.
006-252-01
06.15.99 FM2514
Optical fiber cable
How to work the tension member
[Attach] Tension
member
(Exposed portion of tension member)
[Cut] Insulation tube
[Cover]
[Bend] Tension member
Insulation
washer
Insulation bushing
FM-DP L Service Manual
BA1-33
[Cut] Tension member
5 mm approx.
Mounting screw
Tension member
FP3B0944.EPS
BA1-33
Advertisement
Table of Contents
