Advertisement
4.3 Ready to start up
Figure 4.25
Figure 4.26
Figure 4.27
Please find the tube to the Hydrogen
supply valve, connect it to the regulator.
Then set the regulator value to operating
pressure: 0.5bar/15SLPM.
NOTE: The type of the regulator
used for example may be
different from yours.
Warning!
Make sure the pressure of the hydrogen
supply is maintained at 0.5 barg. This is
critical especially during high flow rate at
higher power output.
Please place the ambient temperature
sensor opposite to the blower side of the
stack. The place where the air comes in
Step 15
Step 16
39
Advertisement
