Advertisement
Step 11
Connect the start up battery (not
included in the system); it could be any
DC power source with 12VDC, current
above 4ampere.
First, connect the cable to the start up
battery.
Then plug the cable connector to the
controller, as showed in fig 4.16
Figure 4.16
NOTE: It is NOT suggested to
plug the battery cable to the
controller BEFORE it connects to
the battery, as showed in fig 4.17.
Warning!
Please observe the polarity of the
wire. Wrong polarity will damage
the controller.
Figure 4.17
35
Advertisement
