Advertisement
4.0 SYSTEM SET UP
To operate H-1000XP, the following items and resource are needed,
● 12VDC Start up power source
● Hydrogen source(operating pressure: 0.5bar / flow rate: 15SL/MIN )
H-1000XP is a self-sustainable system once it is started, to start up the system,
a 12V power source is required, and it could be a battery (current above
4Ampere) or a 12VDC power supply with current above 4Ampere
please follow the steps carefully to set up the system，please DOT NOT feed
the system with hydrogen and DO NOT connect power supply to the controller
before all parts are properly connected.
4.1 Setup gas line to the stack
Since H-1000XP stack has two hydrogen inlet port and two outlet port,
therefore a proper gas line need to be connected to make the system work as
designed, please DO NOT mismatch hydrogen inlet and outlet port, which will
result in stack under performance and possible damage!!! Please refer to the
label on the stack and pay special attention to the arrow on the solenoid valve.
Figure 4.1
Figure 4.2
Make gas line for hydrogen inlet, connect
two tubes(
prefer each tube length
Φ6 /
less than 50cm) to the three way port, as
showed in fig 4.1 and 4.2,
Repeat step 1 to make a gas line for
hydrogen outlet
Step 1
28
Advertisement
