PRx Performance Profile PRO Squat Rack with Pull-Up Bar Install Instructions Manual page 8

Attach Pull-Up Bar and Linkage Arms
Upper Linkage Arms
1. Attach either linkage arm by removing the 5/8" x 5" hex head bolt (#13) from the top of the pull-up bar.
Place the plastic spacer (#9) on the inside of the linkage arm and place it against the top hole of the
upright.
2. Attach linkage arm, black plastic spacer, upright and pull-up bar using the 5/8" x 5" hex head bolt
(#13), two 5/8" flat washers (#11), and 5/8" Nylock nut (#12). NOTE: DO NOT over tighten.
3. Repeat on the opposite side.
Lower Linkage Arms
1. Place plastic spacer on the inside of the bottom linkage arms, place it against the 19" hole of the
upright. Attach linkage arm, plastic spacer (#9) and upright using a 5/8" x 4 1/2" bolt (#14), (2) 5/8"
washer (#11) and 5/8" Nylock nut (#12). DO NOT ATTACH THE SHOCKS. The lower linkage arm
should appear at the same angle as the upper linkage arms.
2. Repeat on the opposite side, being sure not to over tighten.
14
8
11
13
9
11
9
(701) 566-0452
11
12
12
11