Advertisement
PoE Output
IEEE 802.3af/at, per port 30W, 1/2(+), 3/6(-)
Setup and States
a) Connect the Ethernet port of the media converter to a PoE IP camera (PoE device) or network
device with a network cable.
b) Insert the appropriate SFP into the SFP port. Connect the fiber cable from the device (media
converter or switch) on the other end to the LC connector of the SFP.
c) After the device is powered on, the PWR indicator will all be on. If the indicators are not on,
check the power supply connection.
d) After all cables are correctly connected, the indicators will be lit as per port status LEDs.
e) LED
Power :PWR
SFP port：LK/ACT
LAN port states（Yellow）
LAN port （Green）
FALL
General
To ensure trouble free transportation and storage, all OT Systems products must be thoroughly
inspected, tested and properly packed before delivery. Check the product upon receipt for any
visible damage which may have been caused during shipment.
Indicators
ON
OFF
ON
Blink
OFF
ON
Blink
OFF
ON
OFF
Blink
-END-
Quick Installation Guide
ET1212Pp-S-DR/ version 2.2
Description
POWER ON
NO POWER input
SFP connected
Transmitting or receiving data
SFP disconnected
Connected
Transmitting or receiving data
Disconnected
POE ON
POE OFF
Operating
OT Systems Ltd. | www.ot-systems.com
Advertisement
