Gaggenau AL400122 User Manual And Installation Instructions page 17

Drill holes with a diameter of 6 mm four times.
2.
Ensure that the angle of the cut surface to the work-
3.
top is 90°.
Seal the cut surfaces so that they are heat-resistant
4.
and waterproof.
Ensure that the worktop has sufficient load-bearing
5.
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
Ensure that the fitted unit is still stable after the cut-
6.
outs have been made.
Observe the minimum clearances of 10 mm
7.
between the bottom of the appliance and unit parts.
Remove any shavings.
8.
Removing the transit bolts
Unscrew the 2 panels on the front side of the appli-
1.
ance.
Unscrew the 2 screws on the underside of the appli-
2.
ance.
Close off the holes on the underside of the appli-
3.
ance using the locking caps.
Keep the transit bolts safe.
4.
Reinstall the transit bolts before transporting the ap-
pliance.
Installation instructions en
17