Software Control Panel - ICON UMIX1010 RACK Manual

Software control panel

1. Sample rate settings

Select your desired sampling rate from 44.1kHz
to 192kHz on the pull down window shown in
Diagram 24. Click "Apply" after the selection
has been made to set the value.
2. Buffer Size settings

You may select the buffer size for "Streaming"
and "ASIO". Click "Apply" after you have made
the selections.

Note: If a clicking sound occurs, you should
change to a larger buffer size for the settings.
If the largest buffer size has been selected and
there is still a clicking sound, it means your
computer performance is not able to handle the
task. (It is not caused by the Umix 1010 Rack
digital audio interface)
3. Device settings

Shows the serial number & product ID of your Umix 1010 Rack device. If it
doesn't show, it means your device is not properly installed. Please go through
the "Driver Installation" process again (Page 13).
4. Monitor Mixer

Click this button to launch the "Monitor Mixer"
(Page 17)
5. Playback Mixer

Click this button to launch the "Playback Mixer"
(Page 18)
6. S/PDIF Status and Pass Through

Showing the S/PDIF device signal status.
7. S/PDIF Pass Through

"Tick" the box if you want S/PDIF signal pass
through
16
Diagram 24
Diagram 25
Diagram 26