Setting The Sleep Timer; Setting The Alarm Timer - Taga Harmony HTR-1000CD Instruction Manual

Setting the Sleep Timer

When the CD-Receiver is turned on, repeatedly press the SLEEP button to select a set period of
time (in minutes): 120, 90, 60, 45, 30, 15.
When the Sleep Timer is activated, the [SLEEP] is displayed on the Display.
To deactivate the Sleep Timer
Press the SLEEP button repeatedly until [SLEEP OFF] is displayed on the Display.
When the Sleep Timer is deactivated, [SLEEP] is not displayed.

Setting the Alarm Timer

This unit can be used as an alarm timer (clock).
Note! Make sure that you have set the Clock correctly.
1. In the Standby mode, press and hold the TIMER button, until [TIMER SET] scrolls on the display
and the input is displayed, e.g. DISC.
2. Press the ►►l, l◄◄ buttons on the front panel or
select an input.
3. Press the TIMER button, the hour indicator will blink.
4. Repeat steps 2-3 to set the hour, minute and adjust the volume.
Note!
• To exit the Alarm Timer setting mode without storing, press the ■ button.
• If no button is pressed in 90 seconds, the unit exits the Clock setting mode automatically.
• If the CD/USB input is selected, and no disc or USB Flash Drive is inserted or an incompatible
format is detected, the TUNER input will be activated automatically.
To deactivate or re-activate the Alarm Timer
In the Standby mode, press the TIMER button to activate or deactivate the Alarm Timer.
• If the Alarm Timer is activated, [
• If the Alarm Timer is deactivated, [
,
] is displayed on the Display.
] is not displayed.
buttons on the remote controller to
25