Setting The Clock; Input Selection - Taga Harmony HTR-1000CD Instruction Manual

Hybrid stereo cd-receiver
Hide thumbs Also See for HTR-1000CD:
Table of Contents

Advertisement

Operation

Setting the Clock

Setting the Clock Manually
Note! You can set the Clock in the Standby mode only.
1. In the Standby mode, press and hold the CLOCK button to activate the Clock setting mode,
[24] begins to blink on the Display.
2. Set the 12/24 hour format with the ►►l, l◄◄ on the front panel, or ►l, l◄ buttons on the remote
controller.
3. Press the CLOCK button, the hour indicator will blink.
4. Set the hour with the ►►l, l◄◄ on the front panel, or ►l, l◄ buttons on the remote controller.
5. Press the CLOCK button, the minute indicator will blink.
6. Set the minute with the ►►l, l◄◄ on the front panel, or ►l, l◄ buttons on the remote controller.
7. Press the CLOCK button, the built-in clock starts operating.
Note!
• To exit the Clock setting mode without storing, press the
• If no button is pressed in 90 seconds, the CD-Receiver exits the Clock setting mode automati-
cally.
• If a power failure occurs or the CD-Receiver is disconnected from the electrical outlet, the Clock
setting will be lost.
Setting the Clock Automatically
When the CD-Receiver is tuned in the DAB/RDS station for the first time and when the Clock is
not set, the CD-Receiver can synchronize with the time transmitted by the DAB/RDS station (with
CT information) automatically.
After that, Press the INFO button for over 2 seconds:
» [CT SYNC] is displayed and the CD-Receiver reads the DAB/RDS time.
» If no time signal is received, [NO CT] is displayed.
Display the Clock
In any Input mode, the built-in Clock shows the time on the Display by pressing the CLOCK
button.

INPUT selection

By rotating the INPUT knob on the front panel or pressing one of the function buttons on the
remote controller, select which audio input you want to play.
Double-function buttons on the remote controller (FM/DAB,
press once to choose the first input, press twice to select the second input.
The selected input is indicated on the Display.
Make sure the audio source is properly connected and configured.
button.
/ AUX, AUDIO IN / OPTICAL) –
15

Advertisement

Table of Contents
loading

Table of Contents