Using The Remote Control; Reassigning The Input Button - Sony STR-DH130 Operating Instructions Manual

Overview of the menus
x BALANCE (Speaker balance)
Lets you adjust the balance between left and
right speakers.
You can adjust from BAL. L+10 to
BAL. R+10 in 1dB/step.
The initial setting is BAL. 0.
x NAME IN (Naming)
Lets you set the name of inputs and preset
stations. For details, see "Naming inputs"
(page 20) and "Naming preset stations"
(page 25).
x AUTO.STBY (Auto Standby)
Lets you set the receiver switch to standby
mode automatically when you do not operate
the receiver or when there is no signals input to
the receiver.
• STBY ON
Switches to standby mode after
approximately 30 minutes.
• STBY OFF
Does not switch to standby mode.
Notes
• This function does not work when TUNER input is
selected.
• If you use the Auto standby mode and the Sleep
Timer at the same time, the Sleep Timer has
priority.

Using the Remote Control

Reassigning the input
button
You can change the default settings of the
input buttons to suit the equipment in your
system. For example, if you connect a Blu-ray
Disc player to the SAT jack on the receiver,
you can set the SAT button on this remote
control to control the Blu-ray Disc player.
Note
You cannot reassign the TUNER and PORTABLE
input buttons.
1
Hold down the input button of
which you want to change the
assignment.
Example: Hold down SAT.
2
Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 8.
Now you can use the SAT button to
control the Blu-ray Disc player.
continued
GB
27