Sony STR-DH130 Service Manual

SERVICE MANUAL
Ver. 1.0 2012.01
Specifi cations
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(US model only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than 0.09%
total harmonic distortion from 250 milliwatts to
rated output.
Amplifi er section
US, Canadian and AEP models
1)
Minimum RMS Output Power (8 ohms, 20 Hz –
20 kHz, THD 0.09%)
90 W + 90 W
Stereo Mode Output Power (8 ohms, 1 kHz,
THD 1%)
100 W + 100 W
Measured under the following conditions:
1)
Area Power requirements
US, Canadian 120 V AC, 60 Hz
AEP 230 V AC, 50 Hz
Frequency response
Analog 10 Hz – 70 kHz
+0.5/–2 dB (with BASS =
0 dB, TREBLE = 0 dB)
Input
Analog (PORTABLE IN)
Sensitivity: 1 V/
50 kilohms
S/N 2) : 96 dB (A, 500 mV
Inputs
Analog (Except PORTABLE IN)
Sensitivity: 500 mV/
50 kilohms
S/N 2) : 96 dB (A, 500 mV
Outputs
Analog (AUDIO OUT)
Voltage: 500 mV/
10 kilohms
9-890-596-01
Sony Corporation
2012A08-1
©
2012.01 Published by Sony EMCS (Malaysia) PG Tec
STR-DH130
Tone
Gain levels ±10 dB, 1 dB step
INPUT SHORT (with BASS = 0 dB, TREBLE =
2)
0 dB).
3) Weighted network, input level.
FM tuner section
Tuning range 87.5 MHz – 108.0 MHz
Antenna (aerial) FM wire antenna (aerial)
Antenna (aerial) terminals
75 ohms, unbalanced
AM tuner section
Tuning range
Area Tuning scale
10 kHz step
US, Canadian 530 kHz –
1,710 kHz
–
AEP
Antenna (aerial) Loop antenna (aerial)
General
Power requirements
Area Power requirements
US, Canadian 120 V AC, 60 Hz
AEP 230 V AC, 50/60 Hz
Power consumption 200 W
Power consumption (during standby mode)
0.3 W
Dimensions (w/h/d) (Approx.)
430 mm × 132.5 mm ×
279 mm (17 in × 5 1/4 in ×
11 in) including projecting
parts and controls
Mass (Approx.) 6.4 kg (14 lb 2 oz)
3) )
3) )
Canadian Model
Supplied accessories
Operating Instructions
Quick Setup Guide
FM wire antenna (aerial) (1)
AM loop antenna (aerial) (1)
9 kHz step
531 kHz –
Remote control (RM-AAU130) (1)
1,710 kHz
531 kHz –
1,602 kHz
R6 (size AA) batteries (2)
Design and specifi cations are subject to
change without notice.
Halogenated fl ame retardants are not used in
the certain printed wiring boards.
FM STEREO / FM-AM RECEIVER
US Model
AEP Model