Using The Wired Remote Control; Using The Rear View Camera - Sony XAV-AX5600 Operating Instructions Manual

Hide thumbs Also See for XAV-AX5600:
Table of Contents

Advertisement

Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base  to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.

Using the wired remote control

When using the steering wheel remote
control
Installation of the connection cable RC-SR1  is
required before use.
1
To enable the steering wheel remote control, select
[General]  [Steering Control]  [Custom] 
make the registration.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 
• Refer to the support site for details then connect each lead
properly to the appropriate leads. Making an improper
connection may damage the unit.
URL: https://www.sony.com/am/support
• Consulting the dealer or an experienced technician for
help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General] to [Preset].
Using an HDMI device
Installation of an HDMI cable (not supplied) is
required before use.
1
Connect an HDMI cable to the HDMI
terminal at the back panel of the unit.
2
Pass the cable tie  through the cable
holder, then tie the cable tie  around the
HDMI cable.
The HDMI cable is secured to the unit.
*
to
* HDMI cable (not supplied)
3
Connect the installed HDMI cable to an
HDMI device.
4
Press HOME, then touch [HDMI].
The HDMI device connected will be mirrored to
this unit.

Using the rear view camera

Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
15
GB

Advertisement

Table of Contents
loading

Table of Contents