Table of Contents
Advertisement
AU
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Level the appliance by adjusting the screw
feet.
Fit Glass Panels
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the
collar for the grub screw faces
inwards.
2. Slot the two side panels into the collars, with
the holes in the glass at the top.
Note: Ensure the screw hole
furthest from the edge of the
panel goes to the back of the
appliance.
3. Screw a grub screw into each collar to secure
the panels.
Note: Ensure the soft end of the
grub screw is the end making
contact with the glass.
Do not overtighten the grub
screws as it will result in the
glass breaking.
4
GD875-A_GD876-A_GD877-A_A5_v5_20191129.indb 4
GD875-A_GD876-A_GD877-A_A5_v5_20191129.indb 4
Telephone Helpline: 1300225960
4. Slot the rear panel into the collars, with the
holes in the glass at the top.
5. Screw a grub screw into each collar to secure
the panel.
6. Slot the plastic plugs into each of the holes.
7. Screw the brackets to the inside of each pane
using the bolt assemblies.
Note: Ensure the short end
of the bolt assembly is on the
outside of the panels.
8. Place the top panel onto the brackets, ensuring
all holes line up.
9. Insert the plugs and attach the top panel to
the brackets with the bolt assembly.
Bracket
Glass Panel
Bolt Assembly
Plug
Bolt Assembly
Operation
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
•
Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
•
Ensure gastronorm bays are full at all times,
even if the gastronorms are unused or empty.
Empty bays will greatly reduce efficiency of the
appliance.
•
Do not obstruct the fans inside the appliance.
•
Use the spacer bars provided to fill any gaps
(they are not required to support each GN
pans).
•
Always cover the pan with lid when not in use.
•
Do not place hot food or liquid inside the
appliance.
Note: The appliance is not intended for the
long term storage of food.
2021/2/1 14:39
2021/2/1 14:39
Advertisement
Table of Contents
