Error Codes - Sony STR-DG600 Operating Instructions Manual

Error and warning codes

Error codes

When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follows:
Error code t blank display t (error code t
a)
blank display) t PUSH t blank display
t ENTER
a)
Appears when there are more than one error code.
To rectify the error
1
Record down the error code.
2
Press the control button.
3
Press ?/1 to turn off the receiver.
4
Rectify the error.
For details, see "Error code and remedies"
below.
5
Turn on the receiver and perform Auto
Calibration again (page 33).
Error code and remedies
Error Explanation
code
ERROR 10 The environment
is too noisy.
ERROR 11 The speakers are
placed too near
the optimizer
microphone.
ERROR 20 Front speakers
are not detected
or only one front
speaker is
detected.
ERROR 21 Only one
surround speaker
is detected.
34 US
Remedies
Make sure the
environment is
quiet during Auto
Calibration.
Place your speakers
further away from
the optimizer
microphone.
Check the front
speaker
connection.
Check the surround
speaker
connection.
Error Explanation
code
ERROR 22 Only one
surround back
speaker is
detected.
ERROR 23 Surround back
speaker is
detected but
surround
speakers are not
connected.
Warning codes
During Auto Calibration, the warning code
provides information on the measurement
result. The warning code will appear on the
display cyclically as follows:
Warning code t blank display t (warning
code t blank display)
display t ENTER
b)
Appears when there are more than one warning
code.
You can choose to ignore the warning code as
the Auto Calibration function will
automatically adjust the settings. You can also
change the settings manually.
To change the settings
manually
1
Record down the warning code.
2
Press the control button.
3
Press ?/1 to turn off the receiver.
4
Follow the solution provided in the
"Warning code and solution" below.
5
Turn on the receiver and perform Auto
Calibration again (page 33).
Remedies
Check the surround
back speaker
connection. If you
connect only one
surround back
speaker, connect it
to the SPEAKERS
SURROUND
BACK L terminal.
Be sure to connect
the surround
speakers.
b)
t PUSH t blank