Table of Contents
Advertisement
VigorAccess Installation Guide
3
.
4
.
4
S
c
e
n
a
r
i
3
.
4
.
4
S
c
e
n
a
r
The following picture shows the sample connection between six Slave devices and one
Master device. Here we take PC-1, PC-2 and PC-3 as the examples that connecting to one
Slave device directly and wanting to access the Internet through the Master device.
In the above picture, the user of PC-3 wants to use phone and access the Internet at the
same time; yet PC-1 and PC-2 just want to access the Internet through the connected
Slave and Master devices. As for the connection, please follow the steps below:
1.
Connect PC-3 to number 9 of MDF-1, PC-2 to number 5 of MDF-1 and PC-1 to
number 1 of MDF-1 with Ethernet cable).
2.
Connect the MDF-1 to Line port of the Slave Device -1.
3.
Connect the Phone port of the Slave Device-1 to the matching connector (in this case,
it is number 9, be careful and not to misconnect) to MDF-2 which will be connected
to PSTN. This step is just useful for PC-3 for the user wants to call out through the
Slave Device-1.
4.
Connect UP1 or UP2 port of the Slave Device-1 and G6 port of the Master device
with Ethernet cable. As to the connection among the Master device and Slave
Device-2 to Slave Device-6, please refer to arrow indication shown on the picture.
5.
Connect the Master device and ISP with Fiber cable through UP-G port.
6.
With such connection, all the users of the PCs (connecting to the Slave devices) can
access the Internet through UP-G connector of the Master device. Yet only PC-3 can
call out with a telephone set directly.
Such connection allows 168 ADSL CPE routers (24 from the Master device and 144 from
the Slave Device-1 to Slave Device-6) to connect to outside Internet via the Master device
at one time.
22
o
–
M
a
s
t
e
r
a
n
d
i
o
–
M
a
s
t
e
r
a
n
d
S
i
x
S
l
a
v
e
D
e
v
i
c
e
S
i
x
S
l
a
v
e
D
e
v
i
c
e
s
s
Advertisement
Table of Contents
