Table of Contents
Advertisement
Copyright Information
Copyright
Declarations
Trademarks
Safety Instructions and Approval
Safety
Instructions
Be a Registered
Owner
Firmware & Tools
Updates
Copyright 2006 All rights reserved. This publication contains information that is
protected by copyright. No part may be reproduced, transmitted, transcribed,
stored in a retrieval system, or translated into any language without written
permission from the copyright holders.
The following trademarks are used in this document:
Microsoft is a registered trademark of Microsoft Corp.
Windows, Windows 95, 98, Me, NT, 2000, XP and Explorer are
trademarks of Microsoft Corp.
Apple and Mac OS are registered trademarks of Apple Computer Inc.
Other products may be trademarks or registered trademarks of their
respective manufacturers.
Make sure that the AC power source is in the range of AC 90-260V. The
VigorAccess should be used in a sheltered area, within a temperature range
from -10 to +65 °C and relative humidity in the range of 10% and 95%.
DC power source operating condition: -42 to –56VDC. Do not expose the
VigorAccess to direct sunlight or other heat sources. The housing and
electronic components may be damaged by direct sunlight or heat sources.
Read the quick start guide and installation manual before turning on the
power switch of device.
Locate the emergency power-off switch near the device prior to power
connection.
Fixing the device on chassis to maintain air circulation and stable
condition is recommended.
Do not work alone if the operation environment is dangerous.
Check and avoid the potential hazard for moist environment, and
grounding issue for power cable.
Please turn off the power switch when replacing fuse, installing or
removing chassis.
Do not place the device in a damp or humid place, e.g. a bathroom- (such
as this environment).
Avoid operating cable connection during lightning period.
When you want to dispose of the VigorAccess, please follow local
regulations on conservation of the environment.
Users can replace fuses by removing the module and replace it when
necessary. Other components should be repaired by authorized and
qualified personnel. Do not try to open or repair the device by yourself.
The fuse for AC power inlet should be identical to the following standard:
250VAC, 2A
Web registration is preferred. You can register your VigorAccess via
http://www.draytek.com. Alternatively, fill in the registration card and mail it to
the address found on the reverse side of the card.
Due to the continuous evolution of DrayTek technology, all IP DSLAMs will be
regularly upgraded. Please consult the DrayTek web site for more information on
newest firmware, tools and documents.
http://www.draytek.com
VigorAccess Installation Guide
i
Advertisement
Table of Contents
