Table of Contents
Advertisement
Access Control List by MAC address
It can be configured by per-port. It also supports a MAC address deny list, the
application of the MAC address deny list can be enabled/disabled on a per bridge
port basis.
Access Control List by IP Address
This feature still can be configured by per-port, and enabled/disabled on a per
bridge port basis.
1
.
1
.
4
P
a
c
k
e
t
F
i
l
t
1
.
1
.
4
P
a
c
k
e
t
F
i
l
t
This function is provided for users to setup some rules to filter the specific packets while
receiving packets from logical ports.
VigorAccess supports for rule-based packet filtering, it can be used to implement filtering
required of NetBeui, NetBIOS, DHCP, 802.1x and other protocols.
Filtering Modes
VigorAccess supports for independent rule ordering and rule ID. It means that
rule ID no longer determines the order in which the rule is applied. The rule can
be modified easily; users can replace a rule sequence of a stage on an interface
by another sequence in one step.
Moreover, VigorAccess also supports for capturing unicast and multicast
packets that fail lookup in the forwarding database is provided. Users may write
their own applications to terminate and act on this information. On the other
side, it also supports for capturing packets coming to Control Plane that do not
match any registered filter.
Multiple Filter Stages
VigorAccess supports a concept of multiple filter stages are provided for ingress and
egress filter rules. Moreover, VigorAccess supports an Egress filtering for unicast,
broadcast and multicast traffic. It also supports multiple actions configurations by
per filter rule.
1
.
1
.
5
A
T
M
F
e
a
t
u
1
.
1
.
5
A
T
M
F
e
a
t
u
VigorAccess supports some functions about ATM issue.
Remote CPE Management
VigorAccess supports RAW AAL5 interface for remote CPE management.
Diagnostic Testing
VigorAccess supports OAM-I.610 end-to-end and segment loop back and DELT.
Dynamic Modification
VigorAccess supports a lot of dynamic modifications and is shown as below.
VPI/VCI value (VC should be disabled)
Transmit and receive PDU sizes
Management mode modification per port
Max VPI/VCI bits (interface must be disabled)
Maximum number of VCCs supported
e
r
i
n
g
e
r
i
n
g
r
e
s
r
e
s
VigorAccess Installation Guide
5
Advertisement
Table of Contents
