Table of Contents
Advertisement
Warning: The above figure shows the DC power supply terminal block. It is the lugs
at the wiring end from the power source. The wiring procedure is for
ground-to-ground, positive-to-positive, and negative-to-negative in order. The
ground wire should always be connected first and disconnected last.
3
.
6
O
p
t
i
c
a
l
F
3
.
6
O
p
t
i
c
a
l
F
Before you start to do the optical fiber connection, please read the following warnings
first.
Warnings:
The laser energy of the fiber optic communication channels in the single-mode
will be harmful when operate, especially to the eyes. During normal operation
with cable connection, this energy is confined to the cable with no danger
present.
Because the laser radiation is invisible and may be emitted from the aperture of
the port before connect the cable or protective cap, please avoid exposure to
laser radiation and also do not fix the gaze to open apertures.
The following precautions are to avoid injury when connecting or disconnecting
optical channel.
Always connecting optical cables before power on.
Always keep the protective cap on the optic connector.
Never stare into an optical cable or connector when the connector is not in
use.
This section explains the optical Giga Ethernet interface as trunk interface with SC
connector.
i
b
e
r
C
o
n
n
e
c
t
i
b
e
r
C
o
n
n
e
c
t
i
o
n
i
o
n
VigorAccess Installation Guide
27
Advertisement
Table of Contents
