A nameplate specifies the model number, serial number, voltage, amperage, frequency and manufacturing date. Drawings, electrical diagram and replacement part numbers are included in this manual. DOYON is not responsible for damages to the property or the equipment caused by personnel who is not certified by known organisations. CAUTION...
INSTALLATION WARNINGS INSTALLATION AND SERVICE The dough sheeter must be connected to the utility and electrically grounded in conformity to the effective local regulations. If these are not established, the dough sheeter must be connected according to the National Electrical Code (NFPA 70-XX). This equipment has a male plug that...
IMPORTANT SAFEGUARDS To protect against electrical shock, do not immerse cord, plugs, portable appliance in water or Remove plug from the outlet when the appliance is not in use, before putting on or taking off Do not let cord hang over edge of table or counter or touch hot surfaces. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or is dropped or damaged in any manner.
Remove the plastic security cover on the rollers to clean the rollers. Clean the machine with a brush or a vacuum to take out the excess flour. Remove stain with soap and water. DL12S OPERATION DL18S OPERATION WARNING trying to take out some dough.
FOOT PEDAL ( optional) The pedal connects by a special non-invertible tri-polar connector to the electric/electronic circuit (low voltage) of the rolling machine. After connecting the pedal control to the rolling machine, it is always necessary to press the green start button to confirm the operation. The machine is now ready and when the pedal is pressed one gives the start command to release the stop.
Page 15
PC/10-0045 USA CAPACITOR 16 uF 250VOLTS PC/10-0045 PC/10-0073-N PC/10-0073-M MP/100113/USA 120 VOLTS 60Hz POWER SWITCH MP/100113 PC/10-0310 PC/10-0213-3 PC/10-0041 DL12S DESCRIPTION ROLLER ASSEMBLY FRAME BODY TOP MOTOR SUPPORT STAINLESS STEEL CHUTE BACK LID DRIVING BELT RUBBER LEGS CAPACITOR 8 uF 400VOLTS...
Page 17
BACK ROLLER SCRAPER SPRING SX FRONT ROLLER SCRAPER SPRING DX ROLLER GEAR BOX ECCENTRIC FRONT ROLLER COUPLING BACK ROLLER INSIDE SHAFT FRONT ROLLER INSIDE SHAFT BACK ROLLER DL12S FRONT ROLLER DL12S FRONT ROLLER SCRAPER DL12S BACK ROLLER SCRAPER DL12S PULLEY ROLLER OPENING ADJUSTMENT LEVER...
Page 21
SUPERIOR ROLLER DL18S CODE PC/10-0020-S PC/10-0014 PC/10-0024 PC/10-0024-1 PC/10-0022-1 PC/10-0040 PC/10-0066 PC/10-0064 PC/10-0068 PC/10-0067 DESCRIPTION DL18S SUPERIOR ROLLER GEAR BOX DL18S SUPERIOR ROLLER HOLDER ECCENTRIC SUPERIOR ECCENTRIC SHAFT COUPLING ROLLER OPENING ADJUSTMENT LEVER PULLEY SUPERIOR ROLLER INSIDE SHAFT DL18S SUPERIOR ECCENTRIC INSIDE SHAFT DL18S SUPERIOR FRONT ROLLER DL18S SUPERIOR BACK ROLLER QTÉ...
The extent of the manufacturer’s obligation under this warranty shall be limited to the replacement or repair of defective parts within the warranty period. The decision of the acceptance of the warranty will be made by Doyon Equipment service department, which decision will be final.
Need help?
Do you have a question about the DL12S and is the answer not in the manual?
Questions and answers